Lush Food & Drink

Explainer

Can you wash a waffle maker in the sink?

Not the whole machine: the body holds a heating element and wiring, so it is never submerged. You wipe fixed plates and wash only removable ones at the sink.

By the Lush Editorial Team·Researched & Compared

The short answer is no, not the whole machine, and the reason is simple: a waffle maker is an electrical appliance with a heating element and wiring inside its body, and submerging that in a sink of water is both dangerous and a reliable way to kill it. What you can and should clean is the cooking surface and the parts that detach, which on most machines is enough to get a waffle maker genuinely clean. Our Best Waffle Makers compares the published figures of five of them.

Why the body cannot go in the sink

The plates you cook on are bonded to a heating element, and the element connects to a cord and a thermostat housed in the plastic or metal body. Water that gets into that housing can short the element, corrode the contacts, or leave moisture behind that causes a fault the next time the machine is plugged in. Even a machine that survives the dunk often develops an intermittent fault weeks later, which is harder to diagnose than an obvious failure.

This is the single rule that separates a waffle maker from an ordinary pan: a pan is inert metal and a waffle maker is a sealed electrical device. Everything else about cleaning follows from keeping water out of the body.

What you clean instead

On a fixed-plate machine, the method is to wipe the cooking surface rather than wash it. Let the machine cool, then wipe the plates with a damp cloth or a paper towel, working any trapped batter out of the grid pattern with a soft brush or a wooden skewer. A nonstick plate releases most residue once it is cool, and a little water on the cloth is fine as long as it is the cloth that is wet, not the machine.

On a machine with removable plates, the plates themselves can go to the sink, and some are dishwasher safe, which is worth looking for if easy cleaning matters to you. Once the plates are out, the body is wiped and never submerged. That removable-plate design is the only way to put any part of a waffle maker properly under a tap.

Dealing with baked-on batter

Batter that has run into the hinge or set hard in the grooves is the usual reason people are tempted to submerge the whole machine. The better fix is to loosen it while the plates are still warm, not cold, because set batter softens with residual heat. A damp cloth laid over the closed plates for a minute steams the residue loose without wetting the body.

For a grid that will not clear, a paste of baking soda and a little water worked in with a soft brush lifts stubborn residue, and it rinses off a removable plate or wipes off a fixed one. Avoid metal tools and abrasive scourers on any nonstick surface, because a scratched coating is what makes the next waffle stick.

What happens if it already went in the water

If a waffle maker has already been submerged, do not plug it in to test it. A machine that is switched on while moisture remains in the body is the case most likely to short the element or trip a breaker, and it turns a drying problem into a dead appliance. Unplug it, open it fully, and leave it in a warm, dry place for at least a couple of days so that any water trapped in the housing can evaporate.

Even after it dries, treat the first use with caution and watch for a burning smell, a plug that warms, or a trip at the socket, any of which means water reached the wiring. The honest position is that a fully submerged body may be fine or may be ruined, and there is no way to tell from the outside, which is exactly why the rule is to keep the body out of the sink in the first place rather than to rescue it afterward.

Drying and storage

Whatever you wash, dry it completely before the machine is plugged in again. On removable plates that means drying both faces and the contacts where they seat into the body. On a wiped fixed plate it means letting the surface air dry or running the machine empty for a moment to drive off the last of the moisture, which matters more on a bare metal plate than on a sealed nonstick one.

Store the machine closed and upright once it is dry and cool. A waffle maker put away warm or damp traps moisture against the plates, which is how residue turns into a smell and how a bare plate begins to mark.

Common questions

Can I put my waffle maker under the tap?

Only if it has removable plates, and then only the plates. The body contains a heating element, a thermostat and wiring, and water in that housing can short the element or cause a fault later. On a fixed-plate machine you wipe the surface with a damp cloth instead and keep the body dry.

How do I clean batter out of the grooves?

Loosen it while the plates are still warm rather than cold, because residual heat softens set batter. Lay a damp cloth over the closed plates for a minute to steam it loose, then work the grid with a soft brush or a wooden skewer. A baking soda paste lifts anything stubborn.

Are any waffle maker plates dishwasher safe?

Some removable-plate machines publish dishwasher-safe plates, which is the easiest kind to clean and worth looking for if that matters to you. Fixed plates are not removable and cannot go in a dishwasher, so they are always wiped by hand while the body stays dry.

Will water ruin my waffle maker?

Water on the cooking surface is fine; water inside the body is what does the damage. A submerged body can short the element, corrode the contacts, or develop an intermittent fault weeks later. Keep the cloth wet rather than the machine, and dry any washed plate fully before plugging in.

Can I use soap on the plates?

On a removable plate at the sink, a little dish soap and warm water is fine, then rinse and dry it fully. On a fixed nonstick plate, a damp soapy cloth is enough. Avoid metal tools and abrasive scourers either way, because scratching the nonstick coating is what makes future waffles stick.

Ready to compare actual models?

Our buying guides put five products side by side on the numbers their makers publish.

More questions about waffle makers