How the Five Compare on the Numbers
All five publish a silicone part, and it is a different part on each one. IUNNUI publishes 2.8mm gaskets under stainless clamps. Folinstall publishes a food-grade silicone inner seal in a stainless lid plus a non-slip silicone base. The second Folinstall jar publishes a seal and a free spare gasket. Dwbligt publishes a gasket plus a protective base cover. Kilner’s entire lid is silicone.
Only one figure for the silicone itself exists in this group, and it is IUNNUI’s 2.8mm. Everything else is a material name and a location. Capacities run from three 17oz jars through a 3 liter fermenter to two gallon jars, one published as 3785 ml and the other as 3800 ml, and the mouth openings that are published are 4.3 and 3.3 inches.
One figure has been set aside rather than used. The Folinstall 128 oz listing carries a weight field of 1 lb, and a glass jar holding 3800 ml cannot weigh that. The figure is left in the table marked for what it is and no comparison on this page rests on it. Nothing else in these five listings contradicts itself, which is unusual for a pool this size.
What the Silicone Is Actually Doing
A gasket, a base, or the whole lid
Four of these five use silicone the ordinary way, as a compressible ring that the lid presses onto the glass. IUNNUI puts it under stainless clamps, Dwbligt under a screw lid, and the two Folinstall jars inside a stainless lid and a hinged lid respectively. In every case the silicone is the part doing the sealing and the metal is just the clamp.
Kilner is the exception and the most interesting case here. Its entire lid is silicone, with an air lock built into it to release fermentation gases while preventing air from entering. That is silicone as a structural component rather than a gasket, and it is the only pick on this page where the material does a job beyond sealing.
Silicone used away from the lid
Two picks publish a second silicone part that has nothing to do with the seal. Folinstall publishes a protective non-slip silicone base stated to keep the jar stable and prevent slipping and scratches. Dwbligt publishes an upgraded silicone protective cover for the same purpose, naming non-slip and non-scratch grip on any countertop.
On a gallon jar that is a sensible place to put rubber, because a full one is heavy and glass on stone is a bad combination. Both makers pair that cover with a stainless steel handle for carrying, so the two features are part of one argument about moving a heavy jar safely rather than about food contact.
The Gasket as a Wear Part
The only spare on the page
A silicone gasket is the part of a preserving jar that fails. It compresses, it hardens, it takes on the smell of whatever was last in there, and eventually it stops sealing. Exactly one listing in this group has thought about that: the Folinstall 128 oz jar states an extra free silicone gasket is included, usable as an alternative or stacked with the first.
That stacking note is worth reading twice, because it suggests the two can be used together to take up slack in an older seal. None of the five publishes a way to buy further gaskets, a part number, or an expected life, so after the spare is used the jar is only as good as its remaining seal.
Thickness as the one comparable figure
IUNNUI publishes 2.8mm gaskets, and it is the only number for a silicone part anywhere on this page. A thicker gasket has more material to compress, which generally means more tolerance for an uneven rim and more to lose before the seal fails. Without the other four publishing a figure, that is a reason to prefer IUNNUI rather than a proof of anything.
What none of the five publishes is hardness, grade or a temperature rating for the silicone. Food-grade is the only quality claim made, by Folinstall twice and by Dwbligt. For a page asked specifically about food-safe silicone, that is the honest ceiling of what these listings support.
Jars Around the Seal
Capacity and what each is for
The capacities split this group by use. IUNNUI publishes three 17oz jars, which suits jams, chopped vegetables and small batches rather than whole cucumbers. Kilner publishes a single 3 liter jar described as suited to fermenting large batches and then decanting into smaller jars, which is a workflow rather than a container.
The two gallon jars are the bulk end. Dwbligt publishes 1 gallon or 3785 ml in a two pack and names large-batch fermenting and sun tea. Folinstall publishes 128 oz or 3800 ml and names kombucha, canning and pickling. The second Folinstall jar publishes 1 gallon in a two pack with figures of 5.9 by 5.9 by 9 inches.
Getting things in and out
Three publish a mouth opening. Folinstall publishes an extra-wide 4.3 inch opening on its gallon jar and Dwbligt publishes 4.3 inches as well, both naming filling, scooping and cleaning as the reasons. The Folinstall 128 oz jar publishes a 3.3 inch mouth with a concave neck the maker says prevents spilling when filling with preserves.
IUNNUI and Kilner publish no opening figure. IUNNUI describes a wide-mouth design for scooping without spills and Kilner says nothing at all about its opening, which on a fermenting jar that needs ceramic weights lowered into it is the one figure a buyer would want. Neither gap can be filled from these listings.
Which One Fits Your Kitchen
Preserver who wants a figure, not a word. IUNNUI publishes 2.8mm silicone gaskets under stainless clamps on three 17oz jars, states fridge safe and not microwave safe, and includes eight labels, a marker and a brush.
Preserver lifting a full gallon off a stone counter. Folinstall publishes a food-grade silicone inner seal, a non-slip silicone base, a removable stainless handle and a 4.3 inch mouth, at 5.9 by 5.9 by 9 inches.
Preserver who expects the seal to wear out. The Folinstall 128 oz jar publishes a free spare silicone gasket, a 3.3 inch mouth with a concave neck, 3800 ml of capacity and a dishwasher instruction.
Preserver filling two gallon jars at a time. Dwbligt publishes a fresh-lock silicone gasket, a silicone protective cover under the base, a stainless handle and a 4.3 inch opening, at 3785 ml per jar.
Preserver fermenting rather than storing. Kilner publishes a silicone lid with a built-in air lock, 3 liters of capacity, ceramic weights to keep contents submerged and a recipe booklet, at 3.9 lb.
What We Could Not Verify
These are the things a question about food-safe silicone should be able to settle, and these listings do not settle them. Nothing has been filled in from outside the fact sheet.
- Four of the five publish no thickness, hardness or grade for the silicone, only that it is food-grade.
- No pick publishes a temperature rating for its silicone part, so hot brine is nowhere addressed.
- No pick publishes a replacement route for the gasket once it perishes.
- The Folinstall 128 oz listing carries a 1 lb weight field that cannot describe a 3800 ml glass jar.
- No pick publishes how long the seal lasts or how many cycles it survives.
- IUNNUI and Kilner publish no mouth opening figure, which on a fermenting jar is the figure that matters.